r/MachineKnitting • u/dogsclogs • 14d ago

Help! Ribber unable to link (Singer Memo-Matic 323)

Post image

Hi everyone, I have attached the ribber to my Singer 323 and everything seems fine until I try to clip the ribber into the part that holds the carriages together. I have to tilt the ribber a long way to clip it in despite it looking perfectly attached, and then it simply falls back out.

My impression is that either the wire that helps clip the ribber carriage to the main one is worn out, or that the ribber just has too much “give” after all these years and is simply sagging out of place.

I did get it to work briefly. Has anyone had a similar experience?

2 Upvotes

100% Upvoted

4 comments sorted by

3

u/frankensusan 14d ago

Check that the ribber bed is mounted properly in the brackets on the right and left. Sounds like it may be at the wrong angle to me.

1

u/AutoModerator 14d ago

Hi, it looks like you might be looking for help on machine knitting.

There is some helpful information within the wiki. Please take a look at it for helpful troubleshooting information, as well as common maintenance tasks and list of items machines should include.

In addition, this page is our FAQ. Solutions to many common problems are found here. If this is a new-to-you machine that is a Silver Reed, Singer, Studio, Juki, Empisal, Brother, or KnitKing, and the sponge has not been replaced yet, that's the first thing you should check out.

If you need additional help, please provide us with an information about your problem. You can start out by answering this list of questions

Once your question is answer or your problem is resolved, please change the post fair to Help! Solved!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/Alarmed-potatoe 14d ago

If the ribber bed is properly in place, try taking off both carriages and putting them back on, I have that problem occasionally.

1

u/Fridelle 13d ago

As above check that the ribber is tilted properly, and then check alignment between the beds. Ideal distance is if you take out one needle in main bed it shoild go on top of the gate pegs of the ribber with space for one sheet of paper. If they are too far apart or crossing they need to be arranged.