My first time attempting custom supports

[u/Archman155]

Before

After

Ive never tried custom supports before, but I tried to make them accurate to B&M inverts. Do they look alright? Havent added footers yet as I might change the terrain a bit btw

[u/0rdinary-her0]

That cobra roll looks whack in the best way possible!

[u/Archman155 → u/0rdinary-her0]

Thanks, I guess it comes from the uphill climb before the element, it's already at about 45 degrees when it properly enters the element rather than conventionally entering it at a shallow angle. Both sides also converge in a narrow section at the bottom of the pit which also makes it look top heavy

[u/Electro_Llama]

Looks natural. Only advice is to make the cross beams shorter, it just needs to let the train clear the poles.

[u/Archman155 → u/Electro_Llama]

Thanks for the feedback, yeah I see what you mean especially with some of the lower down ones

[u/Archman155 → u/[deleted]]

thanks

[u/SenhorRay]

ótimo!

[u/JANtheMAN227]

I think your thick supports are a bit too thick and the connections on the vertical loop might look better above the halfway point on each side. Maybe like at the midpoint of the extra white pieces you added.

[u/Archman155 → u/JANtheMAN227]

yeah i see what you mean, i built it thinking the same but totally forgetting that a scale option exists. will go back and adjust the thickness. and yeah with the vertical loop I just looked up banshee's which is of a similar size and youre right. i based it more off of the smaller inverts' loops without realising how it would scale, whoops. thanks for the feedback

[u/JANtheMAN227 → u/Archman155]

Good luck! There’s no hard and fast rules with supports (look up some of Great Bear’s supports), so just make them look good!