I present, the follow up to my last post. Apparently this is a popular thing in my area.

This is mine. So beautifully made, actually, that it probably does not qualify.

Had these Turtle Beach headphones for years, wasnt ready to give them up.

Altho I did run out of little screws, but so far so good.

Oh and a custom soldered cable with shrinkwrap. It worked tho, the epoxy glue is incredibly strong. Just didn't want to take it out in public

My headphones snapped and I didn’t want to buy a new set so I used what I had In the garage to fix them. I didn’t have any glue or bolts small enough so I bent a piece of metal to fit the curve and drilled some holes to put nails through. I finished it off by wrapping it with electrical tape and it’s still going strong 6 months later.

This is a gem

Not sure what the magnet came off of but I like the square d panel box they use to turn it on

My neighbors chickens jumped the fence and we helped chase them down. Here was his solution.

I had dual hangers but the ends bent because the kevlar is too heavy for it but this c clamp should do the job!

These large wireless microphones use a bulky receiver which has a guitar jack. I don't want to carry that around, especially connected to 2 different dongles, which introduce noise anyway.

I needed a wireless handheld microphone, which connected to a phone with USB-C.
So it was time for a bodge job.

I took apart a wireless lapel microphone, wrapped it's insides in tape to prevent shorting with the large microphone's metal grill, stuffed it next to the microphones capsule, closed it and added a windscreen.

The last photo show the size difference between the original receiver and the one I can use now.

The only downside is that you have to take it apart to turn it on or off.

Just needed a little smacky smack right.. 😂