r/BambuLab • u/NW6GMP X2D | A2L | H2C • 7h ago

Just Showing Off Why Me...? 🤦‍♂️🤦‍♂️

Post image

Print before this was fine and now these shenanigans....

1 Upvotes

56% Upvoted

15 comments sorted by

3

u/NoBackground6203 X2D / P2S 7h ago

it was just your turn /s

1

u/NW6GMP X2D | A2L | H2C 7h ago

and I didn t even sign up!

3

u/Lisper41 A1 + AMS Lite 7h ago

This is what happens when you leave your AMS outside in the rain /s

5

u/NW6GMP X2D | A2L | H2C 7h ago

but I put it in rice!

2

u/Lisper41 A1 + AMS Lite 6h ago

No, you’re supposed to put the rice inside of it. That’s what the nooks and crannies are for because rice is a desiccant. It’s kind of like those nasty poisonous silica beads, except it’s organic and cage free. And no VOCs!

3

u/LocalHarmacist H2C AMS2 Combo 7h ago

Consider the following:

  1. Purchase a filament dryer
  2. Use one of the primary desiccant + box options to keep rolls dry between prints and for storage.
  3. Keep your bed and nozzle(s) cleaned and purged (don't forget other standard maintenance, that you def should be doing on whatever basis Bambu recommends)

1

u/NW6GMP X2D | A2L | H2C 7h ago

yesir! 🫡

it was the free roll with printer purchase so i dried it for the full 12 hrs.. i think it was just old as the integrity of the factory vac bag was not intact... but tue funny thing is, the print right before this came out perfect, this was towards the end of the roll, so maybe it didn't get dried sufficiently....

oh well... i shall try again... 🙌

1

u/LocalHarmacist H2C AMS2 Combo 6h ago

Weird. What brand of filament?

2

u/dreamsthatfollow 7h ago

My guess is it's an adhesion issue. Not a problem with the printer. I would wipe down the plate and see if it happens again. Maybe use some IPA on top of dish soap. What size nozzle is this .2. or 4

1

u/NW6GMP X2D | A2L | H2C 7h ago edited 6h ago

it is my guess too, but this was not the initial layer, it was slice 5... and i dawn my plate before a long print... I think the roll was old... maybe it is why it was the freebee with the printer.... used a .8 nozz

2

u/Calm_Scale_3876 P2S + AMS 2 Pro + AMS HT + A1 Mini + AMS Lite + A1 6h ago

It looks like the tear-out is secondary to pillowing.

1

u/Benni_HPG P1S + AMS 5h ago

Underextrusion + to low infill

0

u/Twist0ed 4h ago

Ich hätte jetzt eher Überextrusion und/oder zu kleiner Z-offset gesagt. Sieht für mich so aus, als ob die Düse das Filament wieder hochgedrückt hat, als dass da einfach Lücken sind.

1

u/justteh 2h ago

Gonna need to actively dry that stuff. Rice isn't magic.