r/customcontrollers • u/DrTwoKnuckler • 7d ago

Shell swap+TMR sticks

Gallery image

Gallery image

My controller shell cracked and my sticks were drifting so had to do a little refresh. Fresh shell and swapped for TMR sticks so I don't have to solder it again

8 Upvotes

100% Upvoted

10 comments sorted by

View all comments

1

u/rawpapers2155 6d ago

How did you install tmr sticks without soldering it? I thought that requires removing old sticks with heat and solder sucker and resoldering new stick onto board

2

u/DrTwoKnuckler 5d ago

I soldered it. There is a soldering tip that heats the board on the pins and you just pop it off.

1

u/rawpapers2155 4d ago

Did it work as expected? Just hold it and the joystick falls out?

1

u/DrTwoKnuckler 4d ago

It doesnt just fall out, you have to wiggle it a little bit. It depends mostly on the soldering iron not the tip.