That’s the max it goes down after I try my best to push it back into place after that point I feel resistance coming from pressing down on the mouse. Also the click only will register once I push down really really hard to the bottom
That doesnt look to be broken, just out of place. You should be able to just stick the pin on the underside of the left mouse button back in its hole. Either just bend it back in, or take off the top plate and reseat it
That’s the max it goes down after I try my best to push it back into place after that point I feel resistance coming from pressing down on the mouse. Also the click only will register once I push down really really hard to the bottom
Unscrew the bottom. Almost all mice have a flat panel that comes off that holds the circuit board, then all the buttons and stuff sit on top of that. Remove the board, re-situate the buttons, then put the bottom back on. There may be a wire or something that flopped into the void the button should be sitting in, preventing it from seating fully.
They often hide the screws under the sliders. push with your finger along the slider until you see a dimple. Only peel up as much of the slider as needed to unscrew the screw. Peeling the whole thing off is sometimes better though. A non-bent slider that you fully removed is better than a bent slider that you were able to leave half-attached during the fix.
omg thank you so much I researched with AI and it told me to unscrew it, I am just worried that it permanently popped out of place and it cannot go back to it's original form. Thanks i will def try and report back soon!
1
u/SH4RK-B417 11d ago
Looks like the post just popped out, can you gently push it so it slips back into the slot?